0 Items

Wallpaper Adhesive Flakes

Nov 10, 2020 | Wallpaper Accessories

Wallpaper Adhesive Flakes

Wallpaper adhesive flakes based on Eco-friendly production

Popular wallpaper adhesive powder for home decoration.

Strong viscosity and anti-mildew.


Wallpaper adhesive flakes used modified potato starch as main material, It has strong paste, non-toxic, until- mildew, made of potato, environment friendly product.Can easy mixing and quick dissolve in cold water, suitable for various different kinds of wallpaper.such as common wallpaper, glass fiber wall covering, weaving wallpaper, thick and heavy wallpaper and metal wallpaper etc.


Dilute enough powder into (tap) water using the chart below. Stir to achieve a smooth consistency. Leave mixed product for approximately 5 minutes. After that, stir it again and it is ready-to-use.

Apply the adhesive to the wallpaper, follow wallpaper’s instructions. Starting from the top, roll paper in place, taking care to roll out air bubbles. Immediately remove excess adhesive and any adhesive on pattern side with damp cloth.

After dissolving adhesive may be stored for 7 days in closed bucket. Stir very well before use when was stored more than 1 day.


It requires wall neat clean, dry, no solid, no hole, strong and no dust. First put the powder into percent clean water, churn half minute make sure the powder completely absorb, after three minute then churn. Use the brush to paste mixed glue on finished cutting wallpaper, full of the surrounding, fold and stress two sides five or six minutes so that the paste completely infiltrate the back of paper then it can paste on wall. First should put the wallpaper’s top, use drawknife from up and down, from middle to two sides extrude air bubble. Use wet towel take the extra paste out of the surface wallpaper.

Typical technical data


Modified potato starch


White flake


300-350kg / m3


Approx 9


15000 -18000mPa.s

Ph measured in solution1:30

Viscosity determined in solution 1:30. Measurement taken after 2 mins.

Applying paste:

Brush the paste on the back of the wallpaper.Be sure to cover the entire back of the paper including all edges.Let it sit for 5-6 minutes so that it is absorbed by the paper,then apply the paper to the wall.

Applying paper to the wall: 

After applying the pasted paper to the wall start at the top and brush if form top to bottom,middle to each side,making sure that you squeeze out all the bubbles,when applying the next piece of pasted paper make sure that the design matches.Also remenber that each piece of paper should be parallel with the starting edge of the window or wall you started from. 


After the piece of paper has been placed on the wall and all of the bubbles worked out,the extra paste should be removed with a wet towel.