How to strip old wallpaper? Give you a few small tricks!

Many owners have no idea how to deal with the old wallpaper on the wall when replacing the wallpaper; if you continue to paste fresh wallpaper on the previous wallpaper, the outdated and aged wallpapers may fall off the wall together due to the dampness of the adhesive. The ultimate way to do this is definitely to strip the older wallpaper to ensure that the wall covering sticks to the wall structure more firmly.
Here are some methods to uncover old wallpapers.
Peelable wallpaper
1. Pick an inconspicuous corner near the top of the wall and utilize the tip of the utility knife to get the wallpaper.
2. Try to be close to the wall structure, pinch the part of the wallpaper, and try to take it off from the wall. Strip the wallpaper in your direction, making it easier to remove the wallpaper. Whether it’s a peelable wallpaper, the wallpaper will detach from the wall so long as you are strenuous and moderate.
Cut and infiltrate
1. Use a computer program knife, razor blade or wallpaper scraper to cut the outdated wallpaper horizontally, each slit is about 20 or 25 cm apart.
2. Apply water or wallpaper remover and wait around a few minutes for the wallpaper to totally saturate.
3. Repeat the same process on the next wallpaper strip, then go back to the 1st strip and re-wet it from top to bottom with the formulation.
4. Begin Vinyl Wallpaper stripping the wallpaper with a multi-purpose edging knife with a 8.9 cm wide, movable blade. Beginning with a trim horizontal wallet, the blade is certainly placed under its upper edge and the blade is at an angle of 30 degrees to the horizontal, and the sliding blade scrapes the wetted wallpaper. A wallpaper that is the same width as the squeegee will fall off the blade and roll onto the squeegee as the blade pushes down.
5. Continue steadily to push down before wallpaper can no longer be peeled off. If the scraped wallpaper tape breaks, re-infiltrate this region and begin to scrape another tape.
Steam method
It is not easy to peel off old wallpaper. You can lease a steam engine, but you still need to make use of a wide-blade putty knife to scrape most of the wallpaper.
1. Following the water is scorching, press the steam plate on the wall until the wallpaper on the advantage of the steam plate becomes dark due to moisture. Focus on a strip of paper and steadily peel off the wallpaper throughout.
2. After steaming half of the paper strip, use a nail or a computer program knife to draw up the part of the top of the wallpaper and tear off the wallpaper. If the wallpaper can’t be removed, it can be scraped off with a wall structure scraper. You may want to steam the same region twice or three times to loosen the adhesive for the much longer weeks of the wallpaper.
alcohol
For waterproof coatings, cleaning the wall structure paper glue with alcohol will not cause much harm to the wall. Rather, the volatilization of alcoholic beverages can minimize the harm to the wall. But one thing to note is that the focus of alcohol shouldn’t be too high. Usually, the volatility is normally too large, and it is easy to make the white wall structure turn yellow or dark. This is an extremely bad phenomenon.
salt
This technique uses physical friction. But because salt is a white crystal, you don’t have to worry about the strange color that the friction brings to the wall structure. Along the way of rubbing, you may use white gauze or cloth that can keep salt, pack a small packet of salt, softly rub, gradually you will see that the glue remaining on the wall paper is gradually disappearing, and stuck in At the top of the fabric, you just want to rub and stop to remove the glue from the gauze. The next phase is never to be said.