How exactly to match wallpaper with floor, sofa and curtains

In the process of wallpaper paving, many people think that weighed against parquet wallpaper, plain wallpaper is very simple and far more convenient to use without mosaic. As it happens that basic wallpapers are basic and easy to construct because they haven’t any patterns, but the relative stitching requirements are even more stringent. Plain colors, especially darker plain colors, are relatively more susceptible to seam complications. If the plain wallpaper includes a seam phenomenon, what is the explanation for judging the seam? Then take the right approach.

1. There is a gap
If the seam sometimes appears at 1.5m on leading side, there is absolutely no color difference in the wallpaper. Could it be serious to cope with the seams during construction? Most of the factors behind the seams are due to construction problems.
1. If the wallpaper is a rubberized wallpaper, you can wet the seam with a wet towel, open the wallpaper glue, gently pry open up the wallpaper, and utilize the wallpaper softener to soften the wallpaper to stretch the wallpaper and repair the seams.
2. If it’s a genuine paper wallpaper or a non-woven wallpaper, there is almost no stretchability, so that it can’t be repaired by the above method. The base can be shaded with a paint-coated seam that is very similar in color to the wallpaper.
2.Yin and Yang
When there is obviously zero overall feeling between your wallpaper strips at 1.5m on leading part, the seams of the wallpapers are handled good in close distances, and there is no apparent seam phenomenon. It appears that the wallpaper appears like a color difference, and the colour difference at the seam is certainly relative to the obvious law of deep-shallow-deep-light or shallow-deep-shallow-deep, which might be caused by the yin and yang.
Find the label of the wallpaper and see when there is an alternate label on the top and bottom level of the label – ↑↓.

1. If there is, it requires to end up being alternately pasted according to the logo design, ie: shallow-shallow-deep-deep in accordance with prevent the phenomenon of yin and yang.
2. When there is no logo, it is caused by the quality problem of the wallpaper. There is no solution and it is necessary to respond to the wallpaper sales office.

3 white side
If underneath paper is available to be slightly longer when the dark wallpaper is constructed, you will see a white edge at the seam following the construction. The gap is definitely clearly visible at a distance of 1 1.5 m from the front of the wall.

1. Because the wallpaper is not constructed with basic wallpaper, the seam could be treated by the technique of edging.
2. If the wallpaper has been constructed, it can be used in the same color as the wallpaper. (That is a versatile method)

4 overflow glue
The plain wallpaper isn’t simple to erase after overflowing with glue, and there are residual rubber marks after rubbing.
1. When constructing, be sure to check whether there can be an “along alternate” construction tag on the wallpaper label. If there is this logo, the wallpaper should be positively and negatively posted. If there is still a negative and positive surface area phenomenon, you can test normal stickers again.
2, plain color non-woven wallpaper construction should stay away from spilling glue, prevent wiping, after the wiping strength is large, it may leave traces. In case you are unfortunate plenty of to spill the glue, you should clean the spilled glue in the tiniest range, and the softer color of the simple wallpaper should be gentle.
3, rubber surface ordinary wallpaper, the 1st wallpaper paste for half an hour must focus on check whether the seams of the wallpaper possess offset printing. If there is offset printing, it means that the rubberized wallpaper can’t overflow, and the glue will keep traces.